Voyager Pre-load Instructions

Preload Instructions

Suspension for rubber mount pre-load

Re-preload Instructions

  1. Tools needed: 3/4", 7/16", & 9/16" sockets or wrenches and a torque wrench.
  2. Loosen the (8) 1/2" U-bolt nuts, and (2) 3/8" suspension lock nuts.
  3. Make sure that motorcycle rear air shocks are at 80% capacity. Normal tire pressure on both motorcycle tires.
  4. Roll motorcycle rear tire onto 1/4", 1/2", or 3/4" preload plate. (Preload plate can be wood, metal, or plastic.)
    (What preload should I use? click here)
    (Make sure motorcycle is in first gear when tire is on top of preload plate)
    The more preload the less lean you will have with the motorcycle inside the Voyager Kit.
  5. Now tighten (8) U-bolts to 35 foot lbs. (A torque wrench is needed.) Then tighten completely the (2) suspension lock nuts.
  6. Only 20 PSI on Voyager tires.
  7. Now you are ready to ride again!

Related page: